What are the maintenance precautions for woodworking engraving machine？
（1）Make sure the ground wire is good：
In order to ensure the safety of the woodworking engraving machine during use, it is necessary to take grounding measures at the beginning to better protect the safety of equipment and users. Manufacturers of high-quality and low-cost woodworking engraving machines also remind that the grounding wire must use products of special specifications, and ensure that the power supply can work normally after being grounded to prevent the machine from jumping due to external forces. Greatly prolongs the service life of the equipment.
（2） Note that the cooling water should be smooth：
Usually woodworking engraving machines need to use cooling water. Keep the water flow at this time, because the cooling water can take away the heat generated by the laser tube, and the continuous flow can reduce the temperature to a safe range, otherwise it may overheat and damage the equipment. Therefore, you should always check whether the cooling water of the woodworking engraving machine is smooth. If a problem is found, it should be stopped in time for maintenance.
（3）Wood Cutting Engraver Machines for Furniture Equipment Door Making Pay attention to cleaning and maintain good exhaust：
The machine tool is a very important part of the woodworking engraving machine, so it is necessary to do a good job of cleaning and maintenance of this part to make it run normally. Moreover, since the machine tool of the woodworking engraving machine is also a high-precision core component, extra care should be taken when using it. For example, it must be wiped clean after polishing, and bearings should be kept clean and lubricated. At the same time, each bearing should be oiled regularly, so that the transmission device is flexible and relevant inspection work can be carried out at any time.
The above are several aspects included in the maintenance precautions of woodworking engraving machine. In addition, the laser high voltage button should be used correctly. Good quality woodworking engraving machine manufacturers also introduced that every time a job is completed, if the processing is not continuous, the "laser high pressure" should be turned off at any time. When the machine is working, it is forbidden for the operator to leave to avoid accidents. It is recommended to work continuously for no more than 5 hours. , you can rest for 30 minutes in between. 
Jinan M-Shine Technology Co. , Ltd.
Address: 3-1405 Room, Dongdu International Plaza, Industrial North Road, Licheng District, Jinan City, Shandong, China
Factory Address: 800 meters north of the intersection of Airport Road and Wenliang Road, Licheng District, Jinan City
Mob:+8618766144006（stone） Mob:+8615990994941(leo li)
web:www.m-shine.com
https://mshinetech.en.alibaba.com
Email:info@m-shine.com leoli@m-shine.com
